NEW BLAST PRODUCTS
RB2+2 Robotic Blast System
- Yaskawa Motoman SDA10D dual-arm robot accurately manipulates
component or blast gun or both.
- Two chambers can have different blast guns and / or two
media, or a non-blast process, to shrink cell footprint.
- Advanced media reclamatin options deliver consistent surface
preparation results with unwavering uniformity.
- Interface with in-plant material handling equipment, including
tray conveyor or pallet system.
- Electronic sensors provide feedback on key system functions.
Optional SCADA controls package can support process validation
and quality audit documentation.
Mediblast - for medical products
The Mediblast 1400 stainless steel blast cabinet has been
specially engineered for medical product manufacturers, laboratories
etc, where the introduction of ferrous contamination must
The entire cabinet is manufactured from high quality 316L
stainless steel, and the powerful model 900 blast gun has
both a polyurethane body and a stainless air control jet,
making the Mediblast 1400 ideal for a broad range of medical
surface preparation, finishing and cleaning applications.
Contact us for further information on our automated medical
Click icon for Mediblast 1400 leaflet
Wheelmaster - for etching alloy wheels
This new blast system has been specifically designed for
blast etching alloy wheels, and incorporates many application
specific handling features that enable the operator to use
this wheel blasting system safely, without heavy lifting.
The blasting process produces an even finish with easy sweeps
across the wheel surface and, unlike traditional disc sanders,
it allows both easy penetration of the blast media stream
between the spokes and also very precise localised etching
if required. It also provides a fast and even light etching
to remove only the chipped lacquer on virtually new wheels,
whilst being capable of etching right back to bare metal if
- Specifically designed cabinet allows loading and unloading
of the wheel without any heavy lifting
- Very time efficient compared to labour intensive manual
- Suction or pressure feed options to match application
requirements and budgets
- Ideal business opportunity for bringing the blast process
in-house and adding value
Click icon for Wheelmaster brochere.
(No need for electrical supply)
Aftercoolers are an economical way to remove up to 70% of
water vapor and cool compressed air to usable for blasting
The compressed air discharged from an air compressor screw
is hot - approx. 90°C. Compressed air at these temperatures
contains large quantities of water in vapor form. As the compressed
air cools, this water vapor condenses into a liquid form
Without aftercooler, a 5,7 m3/min compressor operating at
7 bar introduces 170 liter of water into the compressed air
system each day.
Campbell Machinery compressed air aftercoolers ACE and ACP
are designed to cool the air to within 2.7°C to 11°C
of ambient air temperature. As the compressed air cools, up
to 70% of the water vapor present condenses to a liquid and
can be removed from the system.
CS type moisture separator installed at the discharge of the
aftercooler removes most of the liquid moisture and solids
from the compressed air.